AHS01: The Build – Step 6

Requirements

  • Everything from Step 5
  • PIR Motion Sensor
  • Jumper Wire x 3

Connect the PIR Motion Sensor

  1. Connect the GND Pin of the PIR Motion Sensor to the ground as indicated by the black jumper wire on the breadboard
  2. Connect the ACT Pin of the PIR to terminal D7 of the Wemos D1 as indicated by the green jumper wire
  3. Connect PWR Pin of the PIR to 3v power on the breadboard as indicated by the red jumper wire


PreviousThe Build – Step 5

Next The Build – Step 7