AHS01: The Build – Step 5
Requirements
- Everything from Step 4
- 10K Ohm Resistor
- Jumper Wire x 3
Connect Resistor and Jumper Wires
- Connect the remaining unused 10K Ohm resistor to the breadboard as show below
- Connect one terminal of the 10K Ohm resistor the 5v terminal of the Wemos as indicated by the red jumper wire
- Connect the free terminal of the 10K Ohm resistor to terminal D2 of the Wemos as indicated by the blue jumper wire
- Connect the free terminal of the 10K Ohm resister from Step 4 to G (Ground) of the Wemos as indicated by the black jumper wire
PreviousThe Build – Step 4
Next The Build – Step 6