AHS01: The Build – Step 4

Requirements

  • Everything from Step 3
  • 10K Ohm Resistor from AHS01 Kit
  • LED From AHS01 Kit
  • Jumper wire from AHS01 Kit

Connect LED and Resistor

  1. Insert the LED into the breadboard
  2. Connect a 10K Ohm resistor to the negative terminal of the LED
  3. Connect a jumper wire from the positive terminal of the LED to pin D5 on the wemos (as shown by the green wire below)


PreviousThe Build – Step 3

Next The Build – Step 5